Recent content by 86GNER

Looking for a good condition harness/connector that attaches to the Low Pressure Switch (Pressure Cycling Switch) located on the accumulator. The harness has a blue and a green wire running to it. My switch is good but I have a bad connection in the harness/connector. Cant seem to find an...

How would I determine if the switch is bad? I have read a forum post where someone jumped the pigtail (harness) to see if a new Harness they installed was good. How would I go about doing this? I have looked at so many websites that sell replacement connectors/harnesses. Unfortunately, the...

The compressor on my 86 GN does not go on unless I jiggle the connector going to the Low Pressure Switch (Pressure Cycling Switch) on the accumulator. I tried to bend the male prongs out a little on the switch attached to the accumulator and I also tried to bend the female prongs in the harness...

Anyone installed a set of t-top weather seals purchased from Gbodyparts.com. These are not the NOS GM ones they sell but rather what Gbodyparts calls seals from a manufacturer that used to make seals for GM but lost the contract. Gbodyparts says they are not aftermarket. Your help would be...

BWEAVY, I sent you a Private Message.

I ordered original GM weatherstripping. I got them in the mail. Howver, they had a powdery look to them and were a bit dried out. They were also coming apart at the corners where the softer rubber meets the harder rubber. They were not in a bag. Just loose in the box they were shipped in. These...

Anyone know where I could go in the Fort Lauderdale/Palm Beach area to have new t-top weatherstripping installed? I do not want to trust just anyone on this as the originals need to be removed and the area cleaned properly, etc... Thanks.

Is there any way to tell between aftermarket and NOS GM t-top weatherstripping. I am wondering if I got the real thing as I paid for. Thanks.

Thanks for the replys. I know these new oem antennas are hard to get. Usually a few will appear on ebay or in the parts for sale section of the forum. I will wait to see if one appears over the next few weeks. If not, I will either have gbodyparts rebuild it or I will attempt to do it my self.

:wink: The power antenna on my car works quietly and fine. However, the antenna mast is slightly bent forward when extended. Kind of looks weird when driving. I would like to replace it with GM OEM Parts. Of all the past posts on the forum, I have found that there are 3 parts depending on the...

Still Looking

Looking for a new OEM GM power antenna assembly with motor/mast all-in-one. Beleive the part number is 22048604. Thank.

Gn Bumper Fillers Are these GM fillers or Aftermarket?

Is it possible to get a high boost light if the low boost light does not come on (and is not the result of a burned out bulb)?

Thanks for the info. Come to think of it, the top light (Low pressure yellow light) comes on. Its the red high pressure bulb that does not come on. Which way should I turn the high pressure adjustment screw to have the light turn on at a lower pressure?