Recent content by atomictruck

  1. A

    WTB Throttle cable braket for 86-87

    Thanks for the reply. I'm not going to need it though. The stock manifold I bought was delivered today and after quite a bit of measuring, Ive decided to go with a different intake setup. Thanks again, Charles
  2. A

    Parting out low mile 87 GN - Everything is priced to sell

    Throttle cable bracket?? Oooops, never mind. I see that it is gone.
  3. A

    WTB Throttle cable braket for 86-87

    Does anyone have a throttle cable braket for a cold-air setup? Thanks in advance, Charles
  4. A

    BIG PARTS LIST, Snow in April sale

    PM sent.
  5. A

    ecms-are they interchangeable?

    ECM yes, with some differences though (calpack). Check out this site and look under "C3 ECM cross reference". I think GNX is a 1227148... and 1227153 have same program ID $31 but 153 is used on a 3.0L Ludis's Home Page
  6. A

    Fuel Injection vs Carb

    I've been lurking aroung the GN boards for a while. I have many more posts in the thirdgen.org boards (I use a 730 ecm)... I have a 4.1L stroked to 270 cu in and I converted it to EFI. My problem is that my racing body won't allow power adders, but I like the small, light weight, yet powerful...
  7. A

    Revolution XR4 220-224 Hyd Roller Cam.

    No problem. Just thought I'd ask. Good luck, Charles
  8. A

    Revolution XR4 220-224 Hyd Roller Cam.

    Kwikr 1, Do you have the specs on your cam? I might be able to make a three-way deal work for everyone. It is a long story, but I am required to run no power adders, NA only. I was looking at this cam but it is a little too big for my application. If your cam will work for me, I can buy...
See more
Top