Recent content by BDC

Sounds like the same way I've got mine setup. I'm using a JAZ 1gal cell in the spare tire well with the pump mounted below it on the bottom. Works well.

Speaking of pump... Speaking of pump, need to talk to you Julio. Think I need to take ya up on your offer and send my pump to ya.

That looks good. I'm going to have to get one for my car. I also like the big green Tea Party sticker in the back. B

Looking at this gauge stuff brings up a question I've got: Just what kind of pressures does your system hit anyways? I've got the Gain up to 5.8-6 with two M10 nozzles and so far have run it up to 27psi. B

That's killer.

Generally speaking, most EFI systems reference the intake air temperature sensor for marginal to moderate fuel corrections based on swings of air temperature readings in the manifold. An increase in air temp of say 60* (from 70*F to 130*F for example) can be a change of up to 5 or 6% across the...

TAI at BG - Is that one of those piston car things? ;)

Correct. It's been nearly 4 years since my install, but IIRC the low-level LED colors, they're RED and TAN on the wiring. I might be wrong. Anyways, the low-level itself is ground switched while the other side of the LED has switched +12V going to it. It can be from practically any source on the...

They're 1/8" NPT, 10psi check valves and they're mounted just prior to both nozzles. I've attached two photos to show the assembly. From the -3AN brass splitter, it goes to a pair of -3 SS-braided lines. On each one there's the -3 to 1/8"NPT adapter, the aforementioned check valve, the right...

Howdy folks, some of ya'll might know who I am but most I don't think do. I'm a Mazda rotary Rx-7 guy that's been a customer of Julio's for about 4 years now. I purchased and installed my Alkycontrol setup back in July/August of 2006. I originally used a single M15 nozzle but went to a dual M10...

Welcome, Louie. B

Check the buss fuse?

Not to be a smart-ass but I was thinking the same thing. B

Where to put it, where to put it... don't have much room! Already have three pressure gauges on the a-pillar... Oh hey Julio, need to talk to you 'bout nozzle check valve. B

+1. Stick with M1 and only M1. Already been there, done that. B