Silly question, but is there an easy way of keeping new stainless headers (Cruz) looking new besides not driving the car? I have a feeling the answer is no without continued polishing which would be a pain. Just curious if anyone has a "simple" solution
TIA
Mark, I switched to Champion rails and they bolted up fine with my accufab and stock lines if you're going to go that way.
Ordered mine a few years ago from Cal Hartline.
I am looking for 4 bumper support shim/spacers. Through the years I seem to have lost a few and now am looking to space out my rear bumper for better clearance of my fillers. Looking for 4 so I can adjust as necessary.
Thank you!
I was trying to show to contact spots of the bar. Here's a couple more. The best I can grab right now.
It does look as though if I cut the center shaft of the end links it should drop the ends of the bar a bit and therefore clear the frame. UMI did include a pamphlet that mentioned cutting them...
Hello, I just installed a brand new UMI sway bar in place of my stock GN one. Same overall width and size. Problem is now, once I lowered the car, the bar seems to hit the frame on both sides. Bar is centered (as good as can be).
Is this an issue of the end links being too tall or some other...
I've popped this fuse (20amp) two times within the last weeks. I have no idea where to begin looking for what could cause this issue. Any ideas on where to begin? I've never had this issue before with 18+ years of owning the car.