Recent content by Fitman

  1. F

    Jegs brand SSR Star wheel setup

    Thanks for your response. Will I need to roll my rear fenders with the 15x10’s?
  2. F

    Jegs brand SSR Star wheel setup

    Hello I was actually looking at these exact wheels from Jegs today. Exactly what sizes of wheels did you get please? And tires? Think these would be track friendly? Thanks in advance Your car looks killer!
  3. F

    Good evening Brian, My name is Chad Feldman (Fitman) I understand you sell the Alradco...

    Good evening Brian, My name is Chad Feldman (Fitman) I understand you sell the Alradco radiators. If so I am interested one one please sir. Please advise on pricing and shipping to 77657. Thanks in advance -Chad 409-454-0933
  4. F

    Alradco...how do i find them? Need a radiator...

    Am needing a new radiator and my local rad shop wants $600 to rebuild me a new one using some of my old crap...f'n crazy! I can't seem to locate Alradco to purchase a new DAMN good one. Any help would be greatly appreciated everyone!
  5. F

    2-step open loop help....

    Wahoo, I'll do that tonight. Thanks!
  6. F

    2-step open loop help....

    Thanks for your response. Yes I hear/read that quite a bit. Kinda hard to do when honestly only time i drive it is at the track last couple years. Even trailer to track.
  7. F

    2-step open loop help....

    Well I installed some Hawk pads up front that made a huge difference. And I put new long shoes on the rear & roughed up the inside of drums with 80 grit sandpaper. At first I had the shoes to far out adjusted (could hear them grinding going down road) then I adjusted them all the way in. So I...
  8. F

    2-step open loop help....

    Sorry Again which row do I add the pin?
  9. F

    2-step open loop help....

    Thanks man! You've been very very helpful on this project!
  10. F

    Please disregard....accidentally repeated post/thread

    Please disregard this thread It was an accidentally reposted. Please got to previous post with same title. Obviously I cant figure out how to delete this repeated post....
  11. F

    2-step open loop help....

    Installed a BB 2 step last wknd. Now i need to know how to wire 12vdc to #12 pin to stay in an "open loop" to prevent my chip from trying to keep correcting the AFR. Can anyone please give me some assistance on this? I'm sure it's probably on the ECM but what row A,B,C or D?? Obviously I...
  12. F

    2-step or not to 2-step??

    Thanks for your assistance dank GN
  13. F

    2-step or not to 2-step??

    Yes im starting to understand now. So even with AEM showing super lean, with me adding 12vdc to pin 12 will that trick the AEM to display a lower reading or actually try not to correct the AF ratio? So obviously it's not safe for me to activate the 2-step with such a high "reading" on my AEM...
  14. F

    2-step or not to 2-step??

    I only did 2500rpm to see how it works. I was assuming I would be taking it higher to get more boost. Which pin 12 on ECM do I apply the 12 volt direct current? A, B, C, or D? Will this override the 6.1 trying to correct the AF? Thanks again!
  15. F

    2-step or not to 2-step??

    RJC Boost controller 2500rpm pulling 8* timing TT 6.1 chip - not sure if it's closed loop or not... THANK YOU FOR RESPONDING BACK SO FAST
Top