You can type here any text you want

Recent content by forkspear

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!
  1. F

    2-3 bind up

    Is there anything else that might cause a bind up on 2-3 other than the hole in the separator plate when dual feeding? I am running CKs kit. I was running a 2.73 rear end and never had a problem with bind up. I switched to 3.73. I overheated my tranny on the freeway due to a poor cooler setup. I...
  2. F

    direct drum oversize rings?

    Enough said. Im not going to use it
  3. F

    direct drum oversize rings?

    This is for a 2004r
  4. F

    direct drum oversize rings?

    I just bought a rebuilt direct drum. It came with cast iron oversize rings. Are these ok to use or should i try to find some teflon rings instead?
  5. F

    i keep burning 2nd

    cant beat that. ill give you a call tomorrow
  6. F

    i keep burning 2nd

    how much?
  7. F

    i keep burning 2nd

    That was about how much I took off a cut too. On the final cut i turned the speed all the way down and let it go over it twice without changing anything. I thought it came out pretty good. Except the diameter is probably too small. I am debating on trying it on an uncut used drum and running a...
  8. F

    i keep burning 2nd

    That had crossed my mind but I did not want to drive the bushings out because I did not have new ones at the time. The only way I checked the diameter of the drum was wrap the band around it and squeeze it together. There was still a gap between the ends but not as big as I would have liked. I...
  9. F

    i keep burning 2nd

    Yes I drilled a bleed hole
  10. F

    i keep burning 2nd

    With cones in the bushing bores No I did not. I watched both go away as it turned..... I do not remember as it was over 6 months ago. Probably too much. I want to say .030. I could be way off. Never checked. The only manual I have is CKs. I may be wrong but I do not remember a spec listed for...
  11. F

    i keep burning 2nd

    How do you do that? Shifts at light load would be harsh right? I'll do that as soon as I can get it out of the corner of the shop. The drum was not too bad. There was a small spot on the band that wore through to the steel and scratched it. I turned it on a brake lathe. I bought the drum...
  12. F

    i keep burning 2nd

    2004r billet forward drum, CK recalibration kit, bigger 200 servo, dual fed. Its behind a mild small block chevy 400. The transmission worked great after I rebuilt it earlier last year. Up until I overheated the tranny to the point it was puking out oil on the freeway. On a forced downshift to...
  13. F

    ck direct piston question

    I didn't get a chance to call in yesterday. I have the piston without a groove.
  14. F

    ck direct piston question

    Does the forward drum have to be ground down to use CKs direct piston? I am sure he told me when I bought it, but its been a while.
  15. F

    bent forward piston. Is aluminum piston ok?

    So on my first 2004r build I put a bearing in backwards and cut a sealing ring on the input shaft. The forward clutches burned and the piston got bent. I have a spare aluminum piston but it has two holes in it. Is it ok run it like that? Or should i plug them? The transmission is dual fed and...
See more

Online statistics

Members online
32
Guests online
2,350
Total visitors
2,382
Totals may include hidden visitors.

Newest members

Stay Connected

Back
Top