js402's latest activity

  • J
    js402 replied to the thread Sputter around 15lb.
    I'm going to grab a wideband before I go back out so I can keep an eye on afr. For e85 what's a good number to be around???chip timing...
  • J
    Get rid of the non resistor plugs to start. It may be that simple..
  • J
    js402 replied to the thread Sputter around 15lb.
    Yep they'll be put in tomorrow.
  • J
    js402 replied to the thread Sputter around 15lb.
    At an idle it's lean but when I'm on the throttle it's not super rich, 128 to 120 ish but without a wideband I cant give an afr.
  • J
    js402 replied to the thread Sputter around 15lb.
    Right. I just did that to not blow the gasket. I'm in the process of tuning it now and that's when I noticed the stumble.
  • J
    js402 replied to the thread Sputter around 15lb.
    Intercoolers a brand new rjc, hoses have been leak checked for vaccum leaks. I added all the fuel the chip would allow so I don't run...
  • J
    js402 replied to the thread Sputter around 15lb.
    I don't have a wideband ow all I know is at 15psi I still get my 1 to 1 rise and BLM is around 128 to 120
  • J
    js402 replied to the thread Sputter around 15lb.
    No i didn't. When I adjusted I just loosened the bolt an gave it a slight turn.
  • J
    js402 replied to the thread Sputter around 15lb.
    Ok. I'll give it a shot.
  • J
    js402 replied to the thread Sputter around 15lb.
    Take the cam sensor cap off??
  • J
    js402 replied to the thread Sputter around 15lb.
    So I got the cam sensor adjusted so the rpm now reads at 3000 / 25 degrees. Went for a ride and it was gone temporarily. Did a couple...
  • J
    js402 replied to the thread Sputter around 15lb.
    So I turned on switch 3 and it read 4500 so it's 15 degrees retarded. To adjust it would I just turn the cap or the sensor itsself???
  • J
    js402 replied to the thread Sputter around 15lb.
    Rpm limit at 6300
  • J
    js402 replied to the thread Sputter around 15lb.
    According to my tr6, my cam sensor is synced
  • J
    One of the things Brain Lorenz and Cal Hartline had to do to my car on The dyno was move the cam sensor. My car would run fine until...