Recent content by ktm240z
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
K
Meth Failsafe...need opinions..
There is no "absolute" fail-safe setup. Razor relies on a wideband O2 sensor. What if the O2 sensor starts to fail and its readings are incorrect? I utilize a pressure sensor that sends a 0-5v signal to my EMS. My EMS ADDS timing, PULLS primary fuel, and INCREASES boost (through an...- ktm240z
- Post #16
- Forum: Alcohol, Nitrous and Propane Tech
-
K
Fuel replacement % Calculation
It's actually quite easy if you want a "ballpark" number. If your AFR is 11.3 before meth and 10.5 after meth, you still want to be around 11.3 even with meth. The target AFR does not change. So, 11.3/10.5 = 1.08. In other words, your injector PW would decrease by about 8%. It is the same...- ktm240z
- Post #7
- Forum: Alcohol, Nitrous and Propane Tech
-
K
Torco Methanol price $$$ increased !
I just picked up a 5 gallon can of Torco methanol for $35 from Fast Eddies in Orange, California. Another shop down the road was selling it for $35 as well.- ktm240z
- Post #7
- Forum: Alcohol, Nitrous and Propane Tech
-
K
Top End Lube - Any users? Able to run a plain steel or aluminum tank with it?
I stopped by two of my local speed shops looking for a SS cylindrical tank with no luck. Both shops mentioned that I could run a top end lube and then use an aluminum or plain steel tank, as the top end lube inhibits the corrosion properties of methanol. Comp cams and Summit both have large...- ktm240z
- Thread
- Replies: 2
- Forum: Alcohol, Nitrous and Propane Tech
-
K
Razors alky and coolant overflow
That tank looks small. I've been scouring the 'net for a cylindrical SS tank as well that is a minimum of 2 qts. I've been searching for hours with no luck. Also, it does not say if its SS or aluminum.- ktm240z
- Post #7
- Forum: Alcohol, Nitrous and Propane Tech
-
K
Tank Size?
Ok, a little bit more about my car. It is a 2.7L inline 6 with an iron block and aluminum head. Compression is 7.4:1 running dished pistons. It is intercooled with a 24x12x3 intercooler. IAT's are typically around 100 degrees in the manifold. The best gas I have available is...- ktm240z
- Post #3
- Forum: Alcohol, Nitrous and Propane Tech
-
K
Tank Size?
I've been doing a bit of reading around the 'net and can not really find any recommendations on tank sizes. I see 2 quart, 1 gallon, 2.5 gallon, etc. tanks for sale with Coolingmist, Devil's Own and Ebay (all the same tank it appears). A little about my setup. I am running a single 700...- ktm240z
- Thread
- Replies: 3
- Forum: Alcohol, Nitrous and Propane Tech
-
K
Aquamist ALKY kit?
Aquamist Just a little fact about Aquamist.... It has been used on World Rally Cup manufacturer's cars from Ford, Subaru, Skoda, SEAT and Hyundai since 1997. They are not a new player on the market. Their system operates a differently than Coolingmist, Alkycontrol, Devil's Own, etc., in...- ktm240z
- Post #25
- Forum: Alcohol, Nitrous and Propane Tech
