Recent content by MN250R

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!
  1. M

    Boost solenoid hookup for ECUGN

    Ahhh ok, Thank You!
  2. M

    Boost solenoid hookup for ECUGN

    Thanks, i actually tested the power to the two wires that are in the red clip that connects to the stock solenoid, i didnt get any, with either the key on, or running, so i ran the wires from the solenoid to a switched 12 volt source, and the computer wire. Wasnt sure what wires to tap into to...
  3. M

    Boost solenoid hookup for ECUGN

    Great, Thanks!
  4. M

    Boost solenoid hookup for ECUGN

    Hello, im looking to hook my factory boost solenoid back up. Right now its hooked up "tuner style" with a lorenz manual boost controller. Trying to find a drawing or diagram for where the vacuum lines go from the boost solenoid to the turbo/wastegate so i can control it from the ECUGN tuner...
  5. M

    Wanted Pressure switches for 3rd & 4th gear 200R4 AC Delco 8683502, 8642473

    Ya, i just changed the TCC solenoid. That was the problem :)
  6. M

    Wanted Pressure switches for 3rd & 4th gear 200R4 AC Delco 8683502, 8642473

    Thanks! ya, i will check mine.
  7. M

    Wanted Pressure switches for 3rd & 4th gear 200R4 AC Delco 8683502, 8642473

    Thanks!
  8. M

    Wanted Pressure switches for 3rd & 4th gear 200R4 AC Delco 8683502, 8642473

    Hello, im looking to replace my TCC solenoid here this week. Since i was in there, i was going to replace the 3 and 4 gear pressure switch. I see the 3RD gear was an AC delco 8683502, And 4th gear pressure witch was 8642473. They both seem to be out of stock everywhere including summit racing...
  9. M

    Wanted: Powerlogger setup with updated chip for my scanmaster.

    Looking for a powerlogger system with the upgraded chip for scanmaster.
  10. M

    Recommendation on transmission builders in Minnesota

    Thank You!
  11. M

    Recommendation on transmission builders in Minnesota

    Hello, looking for reputable builders in MN that are familiar with our 200r4 GN trannys. I had mine done years ago, but have never been real happy with the outcome. SHifts real hard from first to 2nd, even with the TV cable properly adjusted. Looking to see if someone can look at it. Thank You!
  12. M

    Driveshaft YOKE end location after replacing U-Joints????

    Driveshaft Yoke End?? Well i marked the drive shaft before replacing the ujoints, and somehow my mark burned off from heating the old u-joints out. I noticed their were weights on each end of the drive shaft. A small one and a big one. Usually I take pictures but i forgot to do it. Anyone have...
  13. M

    Maf translator and Maf Sensor

    Hello, looking for a Maf Translator and Maf Sensor if anyoine is parting with one. Thanks!
  14. M

    ECM/ harness/TA headers/3" down pipe/ FAST EZ TCU/ powerlogger/ injectors and misc items

    PM Sent on the Maf Sensor/translator
  15. M

    Looking for a power logger.

    We're you able to get pics on the power logger? Sorry for the late response!
See more

Online statistics

Members online
22
Guests online
9,399
Total visitors
9,421
Totals may include hidden visitors.

Newest members

Stay Connected

Back
Top