Recent content by redd222
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
R
injector wiring help
1 ok figured dat i already gave dat a shot still not working is there any reason why noid light flashes only when engine stops cranking- redd222
- Post #3
- Forum: Engine Tech
-
R
injector wiring help
ok i turn the engine over get no injector pulse untill i stop turning engine over then light comes on checked cam sensor getting spark??????????????:confused: aLSO is there any way to make a hotwire kit 4 the injectors?- redd222
- Thread
- Replies: 3
- Forum: Engine Tech
-
R
injector o rings leaking?
my engine is running rich blm r kinda low stock injectors chip fpr when i spray starting fluid on/at the injectors blm drops even lower. wondering if bad o rings could b the problem for my engine running rich. alsor your blms supposed to drop when u step on the gas.- redd222
- Thread
- Replies: 4
- Forum: Engine Tech
-
R
low blms
my blms r around 108 stock injectors stock turbo stock fpr wondering if a oil leaking from the turbo to the uppipe can cause rich symptoms- redd222
- Thread
- Replies: 2
- Forum: Engine Tech
-
R
average scanmaster readings
can someone tell me what these numbers look like this is while in drive with brake held af 07 l8 59 iny 129 bl 110 clt 192 ats 129 tps .46 iac 43 cc moves up 4 points a time o2 back in forth but mostly around 600-700- redd222
- Post #2
- Forum: Engine Tech
-
R
average scanmaster readings
what r the scanmaster numbers supposed to look like cruising at 45- redd222
- Thread
- Replies: 3
- Forum: Engine Tech
-
R
Difference between turbo and non turbo blocks
the block is the same except for it not having the oil drain for the turbo.no big issue.the internals r different.- redd222
- Post #2
- Forum: Engine Tech
-
R
faulty ecm
while ignition on engine off i get an iac reading of 150 on my scanmaster what could b the cause? or is this normal.- redd222
- Thread
- Replies: 1
- Forum: General Turbo Buick Tech
-
R
faulty ecm
while ignition on engine off i get an iac reading of 150 on my scanmaster what could b the cause- redd222
- Thread
- Replies: 2
- Forum: Engine Tech
-
R
scanmaster reading
waht does your scanmaster read when ignition on engine off for iac- redd222
- Thread
- Replies: 6
- Forum: General Turbo Buick Tech
-
R
cars running like crap
when i try to reset i ground terminals a and b then i wait 30 sec disconnect the iac connector the car turns on but doesnt stay on with out me pushing the gas could this be a problem with the cam sensor being off or is that normal- redd222
- Post #37
- Forum: Engine Tech
