Recent content by Trevor Johnson
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
T
anyone do ceramicoating in DFW
Enduro Powdercoating in Mesquite. 972 288 3570- Trevor Johnson
- Post #2
- Forum: Texas Area
-
T
No stall recommendations yet for "GT" turbos?
Use a 71GT-Q and a 3200 9X11 converter on a 231,, takes about 5 seconds to build 22 psi on the line with a transbrake. It works, 1.44 60ft, but spools way too slow to cut a decent light. I will be raising the stall to 4000 soon.- Trevor Johnson
- Post #13
- Forum: Turbos and turbo related parts
-
T
What size wheel and back spacing
15x10 4.0in BS / 28x10.5x15 ET Drag - Roll fender lip - Aluminum drums-close fit. 15x8 4.5 BS / 275 50 15 drag radial - tons of room 10 in. tread- Trevor Johnson
- Post #8
- Forum: General Turbo Buick Tech
-
T
Smokin'...Heads Responsible?
The valve guides would have to be very loose to actually consume a noticable ammount of oil. A loose valve guide will only have a clearance of .003 and with a positive seal on it will not let a large volume of oil past. A bad giude shouldnt smoke during acceleration unless it was drasticly worn...- Trevor Johnson
- Post #4
- Forum: General Turbo Buick Tech
-
T
Cometic headgaskets
Cometic head gaskets require that both the head and block surface be flat and very smooth. Cometic recomends dry installation, I have had customers use them on many cars and had best luck using a thin spray of copper sealer on both sides to ensure no fluid leakage. They are great gaskets but are...- Trevor Johnson
- Post #5
- Forum: General Turbo Buick Tech
