Recent content by turbottime

Thought I would put this up for other backyard mechanics like me. Had my motor out about 20 years ago and I guess I did not tighten the 3/8 engine to trans bolts enough. Passenger side backed out with 1 missing, driver side slightly loose. Something to check next oil change if you have had your...

Just came across this exact thing putting in my new 60 lb injectors, this info helped Thanks.

Twisted my 440 block and it was a heavy beast but had a blower on it, blower manifold no longer square.

Ya maybe the 2 pcs on the left and the long straight pc for the back window?

You are right, 3 pcs, if you have.

Just for the back window, is it 4 pieces?

Need rear window trim, chrome .

Okay I will take it

Wanted: Dutt neck, also looking for a RJC boost controller

No, never did, not trying to rotate the earth with the car, just tune out the detonation. Sort of out of the loop now,guess you have to buy Scanmaster or Powerlogger.

Hello all, just got a new Dell laptop with windows 8 and installed my Turbolink 4.0. Installed and seems to connect (green lights on cable) but wont open the dash board screen, anyone get Tlink working with windows 8 ?

My driveshaft broke at the rear yoke about 30 feet out after a hard launch with drag radials at the track, wiped out my exhaust system and ripped the floor up abit under the back seat. It was a cromoly shaft with stock u joints. Trying to decide how heavy to go now.

Okay thanks, that is what I was looking for

Its the stock 86-87 TR backplate, I will have to press in a bushing ,then bore it to size as there will only be about a .200" cross section after machining the stock plate.