Recent content by Vertigo107

  1. V

    Precision 6765 exhaust housing.

    Really? Ive not thought of that as a possibility. I don't drive the car very much, and race even less, but I still want the setup to be as efficient as possible.
  2. V

    Precision 6765 exhaust housing.

    Thanks, I really appreciate your input. Trying to make the right move. as I need to replace my headers, and deciding on if I wanna stay 3 bolt, or upgrade to a 4 bolt setup.
  3. V

    Precision 6765 exhaust housing.

    I have a 6765 journal bearing turbo with a 3 bolt exhaust housing, that id like to change to a T4 exhaust housing. I know it's a long shot, but does anyone have one, or know a source? Precision no longer has them, so I wanted to ask here just in case someone might have one stored away...
  4. V

    Power master to vacuum conversion question.

    Thanks for that info!
  5. V

    Power master to vacuum conversion question.

    Quick question about the brake pedal when setting up the EB kit.. How do I know where to drill the new hole for the booster linkage pin? There's not a template or any paperwork that came with the kit. Thanks!
  6. V

    Poston GNX style dash. instructions.

    I did use spade connectors, but there are 4 possible connections available on the speedo.
  7. V

    Poston GNX style dash. instructions.

    would any one with the VDO electronic 160mph speedo be able to tell me where the wires are going into the back of their speedo. I have power and ground in the harness, I just need to know where the last 2 wires plug in to get the speedo to read the MPH.
  8. V

    Poston GNX style dash. instructions.

    They are coming from the VSS. its a 4 wire VSS. 2 wires are tapped into the factory VSS to send signal to the ECM, then i'm left with 1 red and 1 white wire.
  9. V

    Poston GNX style dash. instructions.

    Anyone? I have a red wire and a white wire. I would think one is for sensor input, and maybe one for ? Any advice or help would be greatly appreciated.
  10. V

    Poston GNX style dash. instructions.

    Hi, This may be a long shot, but I'm looking for a install manual or PDF of the old Poston GNX dashboard. I took mine out to change some things, and for the life of me cannot remember where the white and red wires go on the back of the VDO electronic speedometer. Would anyone have access to...
  11. V

    Screw in wheel stud question

    Yeah, it didn't say anything about it on the site, but when they arrived, dual setup!
  12. V

    Screw in wheel stud question

    My new set of 28 spline Moser axles have both screw in and press in holes. ie; dual set up. No extra $$ just strait from Jegs!
  13. V

    Headers, Test Pipe, SS Lift bars, Regulator

    Headers, SS Bars, and Test Pipe all SOLD.
  14. V

    Headers, Test Pipe, SS Lift bars, Regulator

    Hey, I sent them out today. You MAY get them tomorrow, but for sure on Monday. They are coming FedEx express. Thanks again.
  15. V

    Headers, Test Pipe, SS Lift bars, Regulator

    Ok, great. I'll put the box in my trunk.
See more
Top