Can you I.D. these pistons?

[boostmaster]

I bought these pistons from a board member some years ago. I don't remember who. I know they are Ross pistons for a standard bore 4.1 but other than that I don't remember much more about them. I think they are for a stroked set up but don't know for sure. The wrist pins are huge and I was hoping to find some rods to use them in a production 4.1 block. Anyway take a look at the pictures and let me know your thoughts.

Thanks, Pete

 

[Squid4life]

They look like JE or Ross maybe, but where they lightened them is where it would normally say "JE" if that is the case. That is odd how the pins are held in by those "locks", which is held in by the oil ring. First time I have seen that.

I will have to look at my pins/rods at home, but I don't think the pin diam is too far off. I have a set of 6.5" Carrillo's if you can make those fit.

 

[drturbo69]

Sent p.m. Doc