Creating an IC Shroud and Scoop

[Orion231]

Well, mine is busted up bad, and I don't want to spend 140 bucks for a new fibergalss one....I used to make fiberglass skins for experimental aircraft I can do fiberglass easy....anyoen ever thought abotu sheetmetal? or maybe soemtype or rubber? i am not tying to ghetto rig this, but I want a better IC shroud and scoop! LOL Give me soem ideas...

 

[49-blues]

keith mease makes out of aluminum and powdercoats them

 

[QuickWE4]

I use the aluminum shroud custom made by Keith over at Mease Performance.
Powder coated as well. Hangs about 1/2 lower than the stock shroud, and fits perfectly.

Nice piece of work - but I think I paid around 120 bucks for it so you're going to be close in cost to the fiberglass.

I had a pic of this up in an older thread a while back....

Rich

 

[Orion231]

Keith Mease

Thaks, how do I get a hold of such a person?

 

[QuickWE4]

You can reach Keith at measeperformance@hotmail.com



Rich

 

[dpok69]

Heres a kewl trick some people use. They use those rectangle office garbage pails cut the bottom out and mount it as a scoop. Beats spending 120$