f/s Ported iron heads and roller rockers *pics*

[KevinB]

I have been undecided on selling these the last few months, but they are up for sale now for good

What I have is a brand new set of Harland Sharp rockers and ported stock heads. I do not know who ported these and currently have NO flow numbers. The heads have just been pressure checked and given the OK by my machine shop. The EGR ports have been plugged. The combustion chambers have been polished. Intake and exhaust have been ported. As you can see in one of the photos, there is a small imperfection on one of the chambers. I was worried about it but the shop said it was OK. He said that it could be ground down or left alone. I personnally was going to leave alone. The intake ports have been sized to the Fel Pro intake gasket. The heads have Manley valves. They do NOT come with springs or retainers.

I want $425 for the rockers. $500 for the heads. Or I will take $900 for both.
Shipping NOT included. Paypal accepted.

Rollers:

Imperfection on the combustion chamber:

Intake port:

Exhaust Port:

Combustion chamber:

 

[KevinB]

Just dropped the heads off to be flowed. I will have numbers Wednesday.

I forgot to mention that the decks were also just cleaned up too.

 

[19TTA89]

Put me first in line for the heads and Rockers.....I am curious to see what they flow first.

Thank you,
Shawn

 

[KevinB]

Put me first in line for the heads and Rockers.....I am curious to see what they flow first.

Thank you,
Shawn

Actually, you are second. I will let you know what happens.

 

[KevinB]

TTT....These are being flowed Saturday. Look for the numbers on Sunday!

 

[Dr.drivability]

heads

Sent you a PM

 

[KevinB]

TTT

Sale pending on the heads. They flowed 203 @ .550" lift on the intake and 172 @ .550" on the exhaust. All at 28" of water using a 4.00" bore plate. I will post up the full flow test if the deal falls through.


Roller rockers are still for sale. $425 shipped in the 48. Brand new never ran!! $450+ brand new

Also have a ported set of aluminum GN1's I might let go. I just got them but just found out I need 14 bolt heads.
These heads are bad*ss! Flow 235 on the intake and 190 on the exhaust. Ready to bolt on. Has hyd roller cam springs on them. Also comes with T&D roller rockers. $1800 shipped in the 48. I will not take any lower than that for these.