Help wiring speakers to amp??? Same old crap

[87gnblackdemon]

My sister just picked up two 12" JL W6's. I just looked them up and it says they are dual 6ohm. She has a 600w kenwood amp, that needs to get 4ohms to get all 600w. How would I wire these to get all 600w to them. How would I wire the speakers? Then how would I wire them to amp?

 

[87gnblackdemon]

UPDATE!!!!!!!!!!!!!

Speakers are dual voice coil, so I have no clue what ohm they are. They are wired pos to pos, neg to neg.

AMP:
Max power output at 4ohms normal 200wx2, bridged 600wx1
Rated power at 4ohms normal 100wx2, bridged 300wx1
rated power at 2ohms normal 150wx2.


Right now the kid she bought them off of has them bridged to the amp.

 

[mcss383]

http://www.jlaudio.com/tutorials/wiring/2dvc.html

The very first way is how you want to wire them. 6ohm is as good as it gets.

 

[87gnblackdemon]

Correction to my post........ Speakers aren't dual vioce coil, they are single. so now what??

 

[87gnblackdemon]

UPDATE ONCE AGAIN!!!!!!


They are 12" w0 rated at 8ohms a piece, so like I said they are wired in parellel, and then to each channel of amp, so I think everything was done right.

 

[mcss383]

If they are single VC 8ohm pieces, then the parallel wiring was correct.