Greetings all,
I have a SMC setup (mostly). And I am finally going to get around to start to play with it.
I have ~ 100 psi at the nozzle when spraying and I will be running either Eric's alky chip and the commander alky chip ( I have both chips and I believe both are around 21° of timing).
Will the M14 or M15 nozzle be enough to run ~ 26# of boost on 93 octane , or am I going to need a "dual nozzle" setup ? If dual nozzle is needed what am I looking at to run 26# of boost 16 GPH , 20 GPH More than that ?
Oh I will be use Windshield washer fluid that is at a 50/50 mix.
I know I will have to tune for my own setup , But it sure would be nice to be close to begin.
I have a SMC setup (mostly). And I am finally going to get around to start to play with it.
I have ~ 100 psi at the nozzle when spraying and I will be running either Eric's alky chip and the commander alky chip ( I have both chips and I believe both are around 21° of timing).
Will the M14 or M15 nozzle be enough to run ~ 26# of boost on 93 octane , or am I going to need a "dual nozzle" setup ? If dual nozzle is needed what am I looking at to run 26# of boost 16 GPH , 20 GPH More than that ?
Oh I will be use Windshield washer fluid that is at a 50/50 mix.
I know I will have to tune for my own setup , But it sure would be nice to be close to begin.
