Rocker arm shaft broke again ?

[gottype]

Stock heads and block, 210/210 cam, stock rocker arms and shaft. I have the RJC supports on the shaft. This is the 3rd time for this to happen. I took it out today and left it in drive from a dead start, didn't watch tach till it shifted into 3rd but in never went over 5100 rpm in 3rd. This was a brand new shaft, first time out and it broke again ?

What should I try next,these are the heavy duty shafts....

Thanks Jay.

 

[insane6]

Jay, I had the same thing happen after my cam change 212-212 ,bought the solid shafts from fullthrottlespeed ,these things are quailty. I cannot image them breaking . Somewhere in the $90 range. I have about 450 hard miles and 9-12 track runs since install so far so good.

 

[gottype]

Thanks will give them a call today, need to have it ready to go so I can make it to Baytown on the 16th.

Jay

 

[turborambler]

The Power

Sounds like that high rev'n race car is making too much power
for the shafts to handle.

You need to keep momma out of it because it makes you show off....

That silver bullet is a force to be reckon'd with.


signed - the silver trash can...

Rj
http://www.ronansys.com/ramblerturbo/main1.htm

 

[puddinpower]

Thanks will give them a call today, need to have it ready to go so I can make it to Baytown on the 16th.

Jay

Or go with Roller Rockers. Just more money and more adjustable!!!!
That hot motor needs more adjustablity.

Puddin