scan master not working after powerlogger install???

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!

josh rosaaen

Member
Joined
Nov 29, 2012
Messages
262
just installed my powerlogger and chip upgrade and the power logger is working it reads when my car is running but my scan master isnt even turning on. i disconnected the the white wire and ran it to the #7 terminal and put the new chip in anything else i need to do?
 
how do i get boost to display on the scan master do i need to hook anything else up to the power logger?
 
When you get the scanmaster working, hit F3 on the powerlogger screen. On the lower left you'll see a button called 'Scanmaster options'.
 
You installed the new 2.2 chip in the Scan master, correct? Double check all the pins to make sure none are bent or broken. Scan master power and ground still good?

Sent from my QMV7A tablet via Tapatalk.
 
i got it working i had to re seat the chip in the scan master. i turned the boost display on on the scan master options but still no display on the scan master it self theres a bst but thats it
 
3 bar map hooked up? Power logger showing boost?
 
ok thanks sounds like i can just tap into the green wire running off my alky kit car was an original digital dash
 
Back
Top