The Ultimate Stock Appearing Turbo: Ta66-Q-trim

[NCTURBOS]

Ta66 Q-trim built by Limit Engineering, and just "freshened" by them as well. Turbo is in as new condition.

Comes with the H-D actuator, machined inlet bell and your choice of PTE .63 or .85 exhaust housing.

$1,000.00 shipped anywhere in the lower 48-states!!


K.

 

[NCTURBOS]

Pic-2

 

[NCTURBOS]

Q-trim with the PTE .85 test fit on the turbo. The PTE .63 is off to the side.


K.

 

[RICHIE HIGH PSI]

pm sent

 

[NCTURBOS]

pm sent

PM replied.


K.

 

[my 1st gn]

turbo

what stall converter do you need an what is this turbo rated at hp

 

[NCTURBOS]

what stall converter do you need an what is this turbo rated at hp

That depends on many variables. If you run the .85 housing your best bet is a 6-pump Vigilante or a "N" stall Art Carr. If you run the .63 housing you can get away with the 0-pump Vigilante. Camshaft size, compression ratio, etc. can also makes differences in spool rate.

As for HP potential... You can run 130mph+ with a 3500lb. car with this turbo. Low 10's.


K.

 

[Just a Six??]

Will a stock heat shield bolt on over that turbo? Thanks!

 

[NCTURBOS]

Will a stock heat shield bolt on over that turbo? Thanks!

It should, I don't see why it wouldn't. But... I have never tried.

As long as the heat shield fits over the PTE series of exhaust housings it will.


K.

 

[NCTURBOS]

Ta66 Q-trim built by Limit Engineering, and just "freshened" by them as well. Turbo is in as new condition.

Comes with the H-D actuator, machined inlet bell and your choice of PTE .63 or .85 exhaust housing.

$1,000.00 shipped anywhere in the lower 48-states!!


K.

No longer available... Decided to keep it...


K.