Wilwood proportioning valve adapter fittings

[happy4444]

Hey Guys,
Those of you running the wildwood proportioning valve, how did you adapt our lines to the 3/8-24 fittings going into the bottom of the prop. valve?
I’ve been looking for adapters/ fitting etc with no luck.

From what I gather our rear flare nuts on our lines are 9/16-18 and our fronts are 1/2-20.
I would need a 3/8-24 inverted flare male to each of these but... NO ONE MAKES ONE

Any help is appreciated, im loosing my mind. thanks

 

[Turbo6inKY]

I did a Wilwood master and prop valve, removing the stock prop valve.

Here's a write up:
http://blog.andrewdscott.com/?p=21

You are right, there are no adapters to get the rear line attached to a 3/8-24 invert flare. To adapt the rear line, I cut it and used a 3/8" tube compression union to a section of flared 3/8" line with a 5/8-18 inverted flare nut, which I could then adapt down to 3/8-24 and attach to the lines coming from the Wilwood prop valve.

 

[happy4444]

I did a Wilwood master and prop valve, removing the stock prop valve.

Here's a write up:
http://blog.andrewdscott.com/?p=21

You are right, there are no adapters to get the rear line attached to a 3/8-24 invert flare. To adapt the rear line, I cut it and used a 3/8" tube compression union to a section of flared 3/8" line with a 5/8-18 inverted flare nut, which I could then adapt down to 3/8-24 and attach to the lines coming from the Wilwood prop valve.

sending you a PM!