It would but that's a lot of extra oil imo. One .020" orifice flows a lotFinally had a chance to take the front fover off.
Bison,
Do you think drilling two small holes in the pressure port about 0.020 Dia pointed to the chain and the other pointed to the gear will work?
Yeah, thats an option.Small hole in oil galley plug.
Thanks for the pic.
True. I have some 0.017 dia drills and will go with one hole. Will point it to the gear and have the drop off take care of the chain. Just too damn bad it's so hard to see/test it on the motor.It would but that's a lot of extra oil imo. One .020" orifice flows a lot
Sent from my iPhone using Tapatalk
You can view through the fuel pump mountTrue. I have some 0.017 dia drills and will go with one hole. Will point it to the gear and have the drop off take care of the chain. Just too damn bad it's so hard to see/test it on the motor.
You need to verify proper engagement of the gears before doing anything elsei will be doing this after finding my cam sensor gear sharp as a knife.
I picked up a new cam gear and a new plastic sensor gear adding oil to that in hopes of never having to do this again.
this is my ugly stuff -- Billet cam with NO oil mods and only 10k miles on it.You need to verify proper engagement of the gears before doing anything else