Recent content by miz

fixed it.Bad inline fuse.

Heres whats going on.Had to go under dash to fix a bad flasher.Everything was fine until I put the plastic panels back on.Now the power light is not coming for the alky .The red wire is in the fuse block still.Everything else in the car seems to be working.

thanks, it was a bad flasher and a bad bulb.

If left or right blinker is put on light stays solid.One thing I noticed is on both sides one light is alot brighter than other.Left side started working and then went back to solid light.Arrows on dash are solid light also.

I have one with a Dutt neck.

When my car did that it scanmaster said bad ecm. In my situation the ecm was fine the terminals were just wet from rain water leaking into car..

I posted last week about my swaybar clamp breaking and car sitting uneven. Since then its been a nightmare. I put in new coils and shocks in. Replaced with stock moog coils. I found that all my qa1 shocks were bad.:mad: When I got back together I noticed If you push on either corner of the core...

I decided going to try and put new coils in the front. I have a couple questions on spring choices. Since I have drop spindles to I have to run stock coil? I am looking for the coil that gives the most handles.thanks

Here is pics of passenger side

Here are some pics of the drivers side.This is the sides that low.

I took the front end apart today.Iswaped sides with the coils to see if that would change anything. When I put it back down it was still off on drivers side. How do you tell if the coils are bad? When installing I really have to compress coil to get in. Can I over tighten them?

I need some help on what to do next or look for. Everything under my car has less than 1500 miles on it..My car has full spohn suspension front and back,baer brakes drop spindles,moog springs,QA1 shocks.I unhooked the sway bar and still uneven by about 3/4. I looked in lower control arm and...

What may have caused my front swaybar bushing clamshell to break on passenger side? I have spohn performance suspension on my car, but there bar uses stock clamshell. It broke on a 3 hr road trip and it makes car 3/4 inch lower on driver side.

Hers the story on what happened. Picked up my car from shop on Saturday.Only put about 50 miles on transmission. Was just cruising around at 45mph and all of a sudden it was like car went into neutral. Put it from od to d and started moving again. When I got on freeway I noticed car had high rpm...

Do you have them in black? I want them if you do. How do i order them?