Recent content by rmc123

battery side terminals were bad Side terminals of the battery were breaking down under load. Top terminals were ok and the only ones that the parts places tested.

I just took the battery tender off my car and tried to start it. If it hasnt been started in a month or so I will disconnect the orange wire coupling behind the battery and crank it 3x for 10 secounds, then re-conect to make sure it doesnt dry start. I cranked it the first time then went to...

My 4 ways work fine. wouldnt that eliminate it being the problem?

Is it under the hood?

g1970, did you read my post all the way through? or did I miss something?

With my lights off my left turn signal will blink about 1/3 as fast as the right. If the lights are on the left turn signal indicator is lit up on the dash (even though the signal is not on) and the left turn signal will not blink if you turn it on. The flashers work fine and all bulbs are good...

DF,why is that?

GC, I appreciate the info. I have already got the paint special made,and it wernt cheep. I am not doing the spraying its being done by a resto shop. I just want to make sure its being done right. I am trying to save as much original paint on the car as possible.I dont know how much if any...

to match whats on the car, want to keep it as original as possible, Also for touching up chips and scratches on the bumpers............

Thanks for the info. If I were you I would go with the stock front fillers and the glass rears. The whole idea of the soft rubber is to prevent damage when you hit somthing. The glass is very thin but will do a lot more dammage than oem and they could crack if you bumped a sgin post or the back...

dont need, i already have my fillers. need guideance on paint application for lac paint.........

I have a low mile original paint car. I am replacing the front fillers with nos ones and the rears wilth glass, untill Richard comes out with his fillers. I have had the LACQUER paint made special. What needs to be done on the fronts (NOS) to keep them from peeling/ cracking? Also does the glass...

I am using GM fronts(just prime, paint and install) and fiberglass rears. The aftermarket fiberglass has to be fitted,drilled and some prep done to them, then primed and painted. Got my glass ones from Brian at gbody. Hope this helps.....

Thanks, are they a certin size? (my first encounter with these).....

I removed my front fillers and cut the plastic fastners( one each side) that attatch them to the header panel. Are these fastners available at a parts store? Thanks ....