Does anybody have a photo/know location of the '87 analog dash's factory brown wire to the ECM's A10 Terminal, and the input wire going to the Cruise control module?
I think they're around the factory green VSS buffer, with a 3-wire white plug and a 1-wire black plug attached to it.
I'm trying to finally get my GNX dash's speedo, cruise, and TCC lockup fixed. Built a "The_Six" harness combining Caspers' VSS Sender and Tach Module; The_Six has a great tutorial found here .
But because it's been 10 years since the original pieces were removed, wires have been cut and I don't know where to start looking.
Still need to hook up the VSS signal wire to the ECM's A10 wire, and the Caspers Tach Module's yellow wire to the cruise control module input wire.
I'm thinking the white 3-wire connector is at the right of the attached photo, with the red quick connects on it.
I think they're around the factory green VSS buffer, with a 3-wire white plug and a 1-wire black plug attached to it.
I'm trying to finally get my GNX dash's speedo, cruise, and TCC lockup fixed. Built a "The_Six" harness combining Caspers' VSS Sender and Tach Module; The_Six has a great tutorial found here .
But because it's been 10 years since the original pieces were removed, wires have been cut and I don't know where to start looking.
Still need to hook up the VSS signal wire to the ECM's A10 wire, and the Caspers Tach Module's yellow wire to the cruise control module input wire.
I'm thinking the white 3-wire connector is at the right of the attached photo, with the red quick connects on it.