i decided to do a little post on how to fix body panels and your own car by your self. i am going to just start with the basics then i hope to add some fiberglass repair, plastic repair, PDR (paintless dent repair) and some airbushing to this post. i will also add some lead work for charlie and some rust repair but i think charlie almost covered iut all in his post. if i can i will add some custom body work like molding a cowl on to a hood so everything flows smooth. you can see a little of that in my sig. here it all goes i'm sorry to have to make so many post in this thread but its the only way to show people how to do it step by step. the first thing is to get a panel simple enough i choose to do a cutlass door so i can have extras doors for my car... the cutlass dors have two hloes on each edge that need to be welded up as well as some tabs to be cut off. i am not going to be covering that because i think most people can do this themselves. as you can see in the picture the corner is bent down i start with a hammer and dolly to get it close... the next step is to get the panel down to bare metal this panel as you will see was way simpler to just take it all the way down because of all the work it needed.