I run the ATR 14" cold air kit with a Kenne-Bell scoop so I have no room on that side for the tank. I installed mine on the rad fan shroud so it would be easy to fill and mounted the pump and Hobbs switch stealth under the rad support,attached to the Kirban frame brace. I have hooked it up basically the same way you have, power to bat, ground to frame, check valve in correctly and hobbs teed into the same map sensor as you. Do you know roughly how many turns that yours is turned out, full 360 degree turns from turned in? My boost is set for 20# and I am running ethyl alcohol, denatured @98% is states. I will most likely dilute with some H2O. What kind of chip are you running? I am running a Jay Carer street 93, but I have a Red Armstrong 108 chip. I wonder how it would run on alky? Any suggestions. Thanks
Brad