Gunmetal87
Member
- Joined
- Aug 12, 2012
Wanted to see if I could repair speaker panel. The split was about 3/4 ways though.
I used a soldering iron to spot weld underside of crack. Then got a thin paper clip and cut and bent zig zag pieces to use as reinforcement Using soldering iron I heated zig zag pieces into plastic, sand smooth, then applied JB plastic weld.
On the top, used soldering iron to melt a grove into the crack, sanded smooth, then fill with JB plastic weld and sand smooth again.
Cleaned, liightly scuff with scotch brite, duplicolor adhesion promoter, then 3-4 coats of Kirban's interior paint.
Posted from the TurboBuick.Com mobile app
I used a soldering iron to spot weld underside of crack. Then got a thin paper clip and cut and bent zig zag pieces to use as reinforcement Using soldering iron I heated zig zag pieces into plastic, sand smooth, then applied JB plastic weld.
On the top, used soldering iron to melt a grove into the crack, sanded smooth, then fill with JB plastic weld and sand smooth again.
Cleaned, liightly scuff with scotch brite, duplicolor adhesion promoter, then 3-4 coats of Kirban's interior paint.
Posted from the TurboBuick.Com mobile app