Recent content by 8kllr
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
Hi,it did arrive and well boxed.No idea when it will get mounted, My wife broke her elbow last...
Hi,it did arrive and well boxed.No idea when it will get mounted, My wife broke her elbow last month had screws and a plate put on it so I'm not messing with the car till she's through all the rehab Hopefully it does what I think until I move to a bigger ball bearing one a,I'll just put it on my...- 8kllr
- Profile post comment
-
-
-
Cooling fans not working
So I've decided to finally fix the fan temporarily,going to rund jumper off delay relay power wire to other relay on fan,I will be installing an lt4 starter and new dual fans over winter from what I've read seems way to go,my question is do I run wire to high or low relay or both- 8kllr
- Post #20
- Forum: Electrical & Wiring
-
-
68 HPQ/68 Turbonetics BB Turbo $500 shipped
Still have turbo for sale- 8kllr
- Post #8
- Forum: Parts for sale
-
Alky control new kit issues
Hopefully this weekend I can get the new manifold on- 8kllr
- Post #9
- Forum: Alcohol, Nitrous and Propane Tech
-
Alky control new kit issues
I can't get over 20 lbs. With alky control on 8 I do have a bad drivers header leak which just bought a pair that's been repaired hopefully when I put this on it will fix my issue sometimes I can run it a 6.5 rough and no knock the sometimes I have to put it to 8 I don't know- 8kllr
- Post #7
- Forum: Alcohol, Nitrous and Propane Tech
-
-
-
Alky control new kit issues
I got it the damn hose into the throttle body popped off went over car for 2 hours and missed it called alkycontrol talking to them and looking at front of car I finally see it.i feel like a dumbass Turbo maxes with 20# and gain on alky on 3 car runs well now next weekend LS1 maf and translator...- 8kllr
- Post #5
- Forum: Alcohol, Nitrous and Propane Tech
-
Alky control new kit issues
Yes stock ecm With tt chip for alky- 8kllr
- Post #3
- Forum: Alcohol, Nitrous and Propane Tech
-
Alky control new kit issues
Just finished install,did all the tests.tpok car out for a drive wants to die no power ran it up and down street a few times no change.put in garage idle just fine Any ideas Could it be map sensor and can I put old 2 bar back in and try it- 8kllr
- Thread
- Replies: 8
- Forum: Alcohol, Nitrous and Propane Tech
-
Fuel leak
Ended up being fuel line was between downpipe and frame getting rubbed it was rubbed flat Rerouted new one,all good- 8kllr
- Post #16
- Forum: General Turbo Buick Tech
-
Fuel leak
I am pretty sure I will reroute these a little better,they do make them with fittings just not positive on fitting and thread- 8kllr
- Post #15
- Forum: General Turbo Buick Tech
