Recent content by BLACKBADGER

Density Ran across a .density altitude chart. The density at 5200 ft with the temp 100 degrees is just over 9000ft. Sea level same temp. density would be like 2500ft. Even at 0 centigrade/32 degrees,freezing the density altitude at 5200 is equivelent to being at 7000ft. The only time density...

Recently purchased a car that is running red-stripes?? The old build up said the were Bosch red stripes,but the top half is solid red. The sheet says Kinsler 756's(last 3 digits),where as the injector body says Q6, and also in another part of the build up/ flow sheet , calls them Bosch 756's...

Thanks I figured it out any how.

W as driving into work in 4th(overdrive) was coming up on slower traffic. Was going 65 I punched the car to pass slower traffic still in overdrive. Car downshifted and started to pull when all of a sudden it just made a banging sound,and the tranny was slipping high revs. Nursed it down the exit...

Have read alot of good things in regard to the Power Plate. Can it be used with the SMC kit? Every one says it redistributes air inflow to those cylinders that run lean on air(rich). Thus improving performance(i.e Torque) One particular post said that a car would run like a pregnant dog if the...

Thanks! That would be nice Chuck. Thanks for offering. Let me get this new JL chip in and tune to it, as I also have a new walbro 340, I need to install. Would love to have it done once I have things tuned to the best of my abilities. I'll be seeing Lee tommorrow as we will be installing his...

Sweet looking TRICK!!! You still have it in your collection?

Timing Thanks, I actually mentioned I wanted more then 30, I know Mr.Davis runs at least 36* all the way thru, It's an old Conley mag4 I believe? As you well know the high timing makes for better throttle response and quicker spool-up thats why I always ran the Pitbull ,she just came alive with...

SMC wire length. I ended up putting mine on the side of the dash, it isn't stealthy. But I was in a hurry to set mine up. It does come with enough wire to run it to counsel glove box(if you run the wiring thru the passenger side firewall, instead of the recommended driverside firewall. The only...

Black6pack ;) You are absolutely right, you know it's there and as you mention very easy to tune. I just set my FPR at 45 line off and adjusted WOT- 02's with pump-speed and turn on point.,and you don't waste it until you feel the need for speed. My car for what...

Wilkinshc He gets 4 (0-120mph runs) and has a 1/3 of a tank left. Using 2-10 nozzles, pump cranked to max and also coming on at 12psi. Running 24lbs of boost at 22*timing. Check out Smc pump flat-out post above,

Slos-10 I don't have any exact number's but I would imagine a 1/2 gal(canister is a 1/2 gal.can) will get you 6-8 passes. As I haven't been to the track ,it's closed. But there are other's who would know like Mr.URL(Chad) who have track experience with the SMC kit. The system will pay for it's...

SLOS -10 Actually had the unit come on at 12#s of Boost, which was a tad early for my stock-combo,so turned the dial to come on at 14#s.Started off with 15-16 lbs of boost.O2's 830,0KR. Turned the adjustable actuator rod 3 turns, at 18 #s had 02's in the 820's with .9-1.2 KR. Turned the pump...

SLOS-10 Sorry I didn't have the site for you. My car is set-up very similar to yours. 36#'s,stock turbo. Have been running 91 pump and I sneaked it up to 21#'s,still have a little to go. As 02's were 830/0KR, so I'll bump it up a turn to 22#. Sure beats high dollar race gas and it's sure nice...

Wilkinshc I'd actually like to have a 75lb shot on the bottom end. I'll let Streetking give you specifics,he should be back today. Good numbers though! Duttwieler was actually impressed with the little motor, said he ain't seen that kind of oil pressure(60-70) thru all rpm ranges. Well over...