Sounds like new turbo hose, clamps and I will have both motor mounts replaced. My guess is they both could use replacing anyway.
Thanks for the help Steve
I am having a problem with my turbo inlet hose coming off ? I have a 3" S.S. inlet air supply going through an LS-1 maf and a cone air filter.
The last couple of times I drove the car and jumped on it a bit to wake up the turbo, a few minutes later the car would barely run and when
I pulled...
Thanks to everyone for the info.
I ordered the cap from Caspers to have an emergency spare.
My set up is all pretty stock so hopefully it will work in a pinch,
and double hopefully I will never need it.
Again thanks to all !
Steve
I have a general question about the camshaft sensor for the 86 and 87 GN's.
I was searching for a back up to have, simply as a spare and quickly realized that they are very hard to find.
There seems to be a very limited supply and I am wondering what usually fails on them.
I found a...
I converted mine to the old school vacuum setup a few years back. The power master on my car (at least) was always leaking and gave me constant worries of failing at the wrong time.
Never looked back and was one of the best things I did to my car in my opinion.
Good Luck.
I bought one of these a few years back from Caspers electronics. I would verify the correct one for your car with them.
This plugs directly into your a/c plug off the compressor as I recall.
Basically you disconnect that connector and plug this one into it.
It comes with a toggle switch to...