Recent content by BradTSS

Does anyone know who makes the 2004R 12” lock up street strip torque converter for CK Performance?

chris718, When you had my valve body and it's components at your shop this summer, to up the shift points. Did it shift fine for you? Does your tech manual have the necessary information it for me to follow to determine if the above things you mentioned to check are ok or are the cause of...

It was almost hard to tell if it did the 2-1 kickdown, since it was so light. One time I could not tell if it did it but the other two times it felt like it did it but it was very hard to tell and the speed was in the 15-18 range the one time and the other time is was 12ish. Not sure if this...

Put an extra o-ring along with the orange ring seal on the filter and it seems much tighter. I push up on the boost valve and found that it had unstuck itself and was against the snap ring. But I ended up pushing too hard on it and caused it to stick again. Put he pan back on and added an...

Its a Monte Carlo SS trans and valve body. I do have a deep pan (2 1/2 extra quarts) and bottom feed 700R4 filter, but for this last test I only filled it full other wise I go 1 quart over full. I shoved the 700R4 filter in as far as I could, but it never really seems like it fully seated and...

I am wondering if anyone can tell me what the pressure should be at WOT when shifting from 1st to 2nd and 2nd to 3rd. At 1000 rpms in park I have 76psi and 265psi at full tv (pulling on the cable), but at WOT I have 145psi and it will not shift from 1st to 2nd at 6000 rpms unless I let off of...

I am installing the CK servo with 1 large shim and a pin that has 3 grooves on the tip. What is the most accurate way to measure the servo pin travel? Some say install with small spring but not the cushion spring and some say no springs. Where do you take the measurement? I have been using...

Does anyone know the part numbers for the correct intermediate servo cushion spring and servo spring retainer that needs to go with the CK Performance billet servo?