Recent content by Brady

That's how I have it

Update....it was a short in the stock boost gauge....basic install has it retained...i don't need it so unhooked that wire and back in business

How do I order one from bison

Gm should be quality??

Anyone have a part number for a 3 bar replacement

Key on engine off have 5.06 volts on grey wire to map sensor. Green wire has .09 volts....when I blow in tube hard the voltage won't change on green wire. It should unless you can't blow hard enough to make it....i think map is shot?

Test button works, red light comes on and alky sprays. Under boost no activation. Checked vacume line to map and no leaks. Good ground at map. Kit worked fine on a drive last night, stopped at a bar, came back out and it didn't work. What else should I check....im down to a map sensor failure...

what size are the wheels and would you sell 2?

title says it all

any pics....$$$

Looking for a internal waste gate down pipe

ttt

Here's pics, its 2 inch. close up of end off pipe with rust, you can see how far it extends into pipe it goes into next to it

I have a like new flowmaster single muffler system for sale, still has stickers on pipes. Can post pic's if requested. Asking $300, you pay shipping

I dont like the look of boxes all over dash. I want to fab up a plate and mount control box in asytray compartment. It looks like the cable wont be long enough. It also looks like its just computer cable, can I just put in a coupler and run extra line??