Recent content by Craig Gill
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
Schaefer’s racing oil
Yes, Schaefer's is very good oil. Been in my car with flat tappet cam for eight years and 12,000 miles.- Craig Gill
- Post #3
- Forum: General Turbo Buick Tech
-
Is the 206 roller cam still available?
Is the 206 roller cam still available?- Craig Gill
- Profile post
-
Billet Hydraulic Roller Cam and Cam Drive parts- Sold
I'm insterested in cam. PM me Thanks- Craig Gill
- Post #8
- Forum: Parts for sale
-
-
3.8 into a 78 malibu HELP
I put a 200r4 in my Monte Carlo. I like to drive the car a lot on the highway, so OD was a must for me.- Craig Gill
- Post #11
- Forum: HYBRIDS
-
Kenne Bell Boost-a-Pump - 20A for single pump
Still have the Boost a pump?- Craig Gill
- Post #2
- Forum: Parts for sale
-
3.8 into a 78 malibu HELP
Everything worked, minus electric fans. Needed to supply power to the relay, then they worked.- Craig Gill
- Post #9
- Forum: HYBRIDS
-
3.8 into a 78 malibu HELP
The motor harness and ecu harness are all in one harness. I used a 1987 harness in a 1980 Monte Carlo.- Craig Gill
- Post #6
- Forum: HYBRIDS
-
Vacuum line relocation
I'm interested in Cruz kit if still available. Thanks Craig- Craig Gill
- Post #7
- Forum: Engine Tech
-
-
3.8 into a 78 malibu HELP
Should fit. May have to cut some of grill mounts to clear. Not a big deal.- Craig Gill
- Post #4
- Forum: HYBRIDS
-
3.8 into a 78 malibu HELP
Use the frame mounts from t-type and make note of location on t-type. Malibu frame will have hole location already in frame. Just need copy location on Malibu frame for 3.8. Will have room for stock type intercooler.- Craig Gill
- Post #2
- Forum: HYBRIDS
-
Best injectors and turbo combo
If it's running rich, need to adjust amount of fuel. What chip do you have?- Craig Gill
- Post #3
- Forum: General Turbo Buick Tech
-
Scanmaster G not reading anything right.
What size wire should you run to the scanmaster G for power and data?- Craig Gill
- Post #9
- Forum: Scan Tool Tech
-
