Recent content by DavzGN
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
D
0-30 boost gauge and standard duty stock wg actuator
It also works with Turbotweak's SD2 chip Sent from my LM-V405 using Tapatalk- DavzGN
- Post #3
- Forum: Parts wanted
-
D
Anyone know Bob Pederson from Madison, WI (ebay seller: incarnut)?
He is username is dwall on here Sent from my LM-V405 using Tapatalk- DavzGN
- Post #3
- Forum: Turbo Lounge
-
D
Engine wont turn completely by hand. (Stored engine)
Remove the rocker arm assemblies and put a straight edge across the ends of the valve stems Sent from my LM-V405 using Tapatalk- DavzGN
- Post #4
- Forum: Engine Tech
-
D
Scanmaster G Aldldroid error
Trying to connect my Scanmaster G to my phone with Aldldroid. Have the correct ADX file but I am getting an "incorrect response length from ECU (179 vs 180)" error message. Anyone have any ideas on a solution. Tried with disable checksum validation checked and unchecked. Sent from my LM-V405...- DavzGN
- Thread
- Replies: 2
- Forum: Scan Tool Tech
-
D
Blowing oil out of breathers!! Compression test results.
Here's one option for the PCV valve. https://rjcracing.com/product/rjc-pcv/ Sent from my LM-V405 using Tapatalk- DavzGN
- Post #10
- Forum: Engine Tech
-
D
Blowing oil out of breathers!! Compression test results.
Numbers look okay, is the PCV valve stopping boost from entering the crankcase Sent from my LM-V405 using Tapatalk- DavzGN
- Post #2
- Forum: Engine Tech
-
D
E51 available at the pump
Depending on the chip you may need to turn boost, timing and amount of fuel delivered down across the board Sent from my LM-V405 using Tapatalk- DavzGN
- Post #2
- Forum: E85 Technical Forum
-
D
Anyone Running Walbro 255 On E85
The ethanol can handle the increased timing. Sent from my XT1650 using Tapatalk- DavzGN
- Post #20
- Forum: Engine Tech
-
D
Anyone Running Walbro 255 On E85
No. I decreased the amount of boost it was adding but otherwise the ethanol tables were left as delivered Sent from my XT1650 using Tapatalk- DavzGN
- Post #17
- Forum: Engine Tech
-
D
Anyone Running Walbro 255 On E85
I'm running an SD2 chip with a flex fuel sensor so it adjusts timing and boost based on ethanol content Sent from my XT1650 using Tapatalk- DavzGN
- Post #14
- Forum: Engine Tech
-
D
Anyone Running Walbro 255 On E85
I used a fuel line from AutoZone. It may have been something like this...- DavzGN
- Post #8
- Forum: Engine Tech
-
D
Anyone Running Walbro 255 On E85
I've been running e85 for 3 years with stock lines with a Walbro 255. I did upgrade the soft lines outside and in the tank to E85 compatible lines. Still running the stock turbo and 22psi. Sent from my XT1650 using Tapatalk- DavzGN
- Post #4
- Forum: Engine Tech
-
D
Boostless
Definitely would check the connections between the turbo and the engine. Most likely one of those three failed. Sent from my XT1650 using Tapatalk- DavzGN
- Post #3
- Forum: Engine Tech
-
D
109 block or not?
20 bolt oil pan is normally a 109 block Sent from my XT1650 using Tapatalk- DavzGN
- Post #9
- Forum: Engine Tech
