I need to install a cat for inspection... Been many years since I installed my 3" Terry Houston downpipe, Dump pipe and Hooker exhaust.
If I unbolt the dump from the flange will I be able to slip it out of there without losening the Downpipe or the exhaust ?
The dump and cat converter are the...
Used OEM Headlight Bezels $65 Shipped
No Cracks or broken parts.
These were painted years ago. Blemish on the bottom right can easily be wet sanded out.
look around on this site
https://www.garagejournal.com/
Tons of ideas and options there. I ended up going with epoxy and doing it myself. It was less than $500 for my 2 car garage and came out very nice. only regret was I wish Id used more anti-slip. I only used a fraction of the amount it...
Is the stock nylon coated timing set still available ? I thought is was discontinued.
Earl do you still sell completed covers ?
My car has 53K but original chain...thinking about going in this spring
I've been kicking around a 3021 converter for a while for, but am not equipped for a tranny pull and don't really have a connection to get it done . My car has never been in a shop. Car does run and spool very good but it would be a nice treat to change it and open door for a bit bigger snail.
Sad fact is the board is not near what it once was. Seems the Vendor list is shrinking along with activity the post count. There used to be literally pages of new posts in the forum each day.
Why ? A lot of reasons probably. Other boards and options, dwindling interest in these old cars...
I have breathers on both covers too. Between this, no cat converter, & egr disabled, its like Turbo6inKY says, stinks like bad service station. My wife often comments on how bad it smells after I pull into the garage.
Lots of threads for and against this. Here my experience so far.
My car leaks a bit of oil out through the inspection cover hole that seems to be worse if I’m driving her hard.I bought a check valve and a spoolfool drip lip and put them in recently.
Put the valve inline with pcv, no catch can...