There is some rust on bottom of doors and starting to bubble behind rear tires i took care of big rust spot on hood and trunk and needs some attention on roof above windshield that will probably be done in the next week solid frame and trunk
85 t type for sale new- gas tank xp high volume fuel pump hotwire kit adjustable regulator crank sensor moog inner and outter tierods sway bar links and front and rear springs tires also rebuilt turbo from supernatural turbo 87 ecm ignition coil and modul turbo tweek chip scan master and boost...
Well im thinking we found my problems . I didnt have a gasket between throttlebody and turbo also turbo wasnt seated right in the manifold and the Turbo mounting bolt on throttlebody side is stripped out so when i replace all this we will see if it runs oh and also a really good guy on here tod...
I have an 85 t type that i cannot get running i have had multiple problems with this car and its been over a year now I NEED HELP !!!!!! So i am looking for someone that is close to me that could maybe come take a look at it without beating me over the head lol . I am in lancaster pa 17522 . I...
Where is the iac at on the motor and im gonna go start it then check the plugs pulled the #1 and it wasnt wet but getting fuel to the rail and it starts just wont idle unless you give it gas
It was doing it with the 85 maf to but the gas is about 8 months old and its 3/4 of a tank full .Yes the fuel pump sock filter and regulator are all a year old but the injectors are stock and i do have the hotwire kit also .AF 13 L8 35 INT 160 BL 128 CLE 146 TPS.52 IAC 67 CC132 MAL oo . do these...
AF 13 L8 35 INT 160 BL 128 CLE 146 TPS.52 IAC 67 CC132 MAL Those are at about 1800 rpms because it wont stay at idle it drops low and engine jumps and shakes then shuts off . I took o2 out and cleaned it off with clean dry rag but here are my scanmaster results any help
Ok i cant keep the car running when you first start it it idles up like its supposed to but when it drops it wants to stall. Now it does it with the 85 ecm and the 87 ecm i did the 87 ecm ign coil module tt chip lt1 maf and translator well i just put that on because i was using the 85 maf and i...