jlat's latest activity
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
Jto youz Mass holes out there, have U been driving your TB in this heat? I have snot. I hate the hot and humid stuff and I'm sure my 86T...
-
JI am.back been out the group for about ten years . I finally pulled her out of the garage and got her going again.
-
JI gave my GN away back in 2009 or 10 and haven't been on this site in a loooong time. I was finally able to get my new email account...
-
Jjlat reacted to RUQWKNF's post in the thread What’s the purpose of these blue boxes on LH side ? with
Like.
It's happening on a regular computer as well. -
Jjlat reacted to Mr.Spool's post in the thread What’s the purpose of these blue boxes on LH side ? with Like.
Its everywhere
-
Jjlat reacted to 1KWIKSIX's post in the thread What’s the purpose of these blue boxes on LH side ? with Like.
Ok, I find these blue boxes (with text) very annoying ! They take away my ability to see the full thread title . Any way to remove them...
-
JThere's not a day that goes by that I don't wish you luck. ;) :p
-
Jhello peoples: I just ordered a Seal Skin cover and I'm wondering has anyone here has tried one. This is my first cover. Wish me luck. IBBY
-
Jjlat reacted to Mr.Spool's post in the thread Waste gate issue? Turbo too big for set up? with Like.
Send Eric the file👍
-
JRockauto? That accumulator was used on every GM passenger car from 1977 until 1984. It's not an uncommon part (Unless you're not in the...
-
JI put the Right stuff kit AFXRD78Z from summit racing back in 2020 They were a lot cheaper than today. Installed new axles and bearings...
-
JI did the 98 s10 blazer 4dr 2wd brake swap 10 yrs ago,didnt change the prop valve left stock one in it,have 30 spline axels and c clips...
-
JI have done the front brakes with the Blazer setup...very easy, and stops the car quick. I have the inline tube rear brake setup on both...
-
JI have been working on this project for awhile now. You can see my mods in my signature of my 86. I have a TIAL MVI2.5 adjustable...
-
JBy putting an ohm meter across the leads and moving the float the ohms(resistance) should change. The ohms range is different for...
