Recent content by mashux86
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
M
New to the forum, looking for a Buick machinist
Yeah, I've been looking at turbos. I would love to do an intercooler but the location is challenging in a Fiero. A water to air intercooler like the ones offered by Frozenboost with the water radiator up front might be a possibility. Comes down to funds right now, don't know if a turbo is in...- mashux86
- Post #8
- Forum: General Turbo Buick Tech
-
M
New to the forum, looking for a Buick machinist
Hi Earlbrown, thank you for the reply. I should have given more info in the original post. My engine is an 85 and is most like the 20 bolt GN motors not the 3800 (see below). Same heads, rods, pistons, front cover & oil pump set up; crank has the GN rolled fillets but a different flywheel flange...- mashux86
- Post #3
- Forum: General Turbo Buick Tech
-
M
New to the forum, looking for a Buick machinist
Hi all, I am building a 3.8 VIN 3 (FWD) engine for my Fiero swap. I am looking for a Buick knowledgeable machine shop in central / west central NJ. Any suggestions would be greatly appreciated! Very best regards, Mark- mashux86
- Thread
- Replies: 7
- Forum: General Turbo Buick Tech
