Recent content by mred355

Do you still have the timing cover and is the oil pump cover attached?

Thanks to all for the help. It was the # 10 wire from the Battery pos. to the alt stud. It was tanged in the lower harness and I had to look hard to find it. I hooked it up and all is ok now. I do have 3 wires attached to the Alt. pos. terminal and I think the third one is for the after...

I think I didn't explain myself correctly. There in no connection between the hot post on the starter and the hot post on the alternator.

I have no voltage at the charge stud on the alternator. How many wires should be on the stud? All the wires are still on the starter as I havent removed it. All the grounds are connected to the passenger head. Not sure what's next?

Hi Guys. Thanks for all the help up to now. I finally got the valve job and the timing chain and gears done and filled up the oil and antifreeze and was hoping for a quick start. well the starter runs; but no start. The fuel pump won't run. I checked the alternator for voltage and there's...

Thanks Guys for all the help. Ed

Hi Guys. I am having a problem hooking all the wires back up. I did a valve job and timing chain and sprockets and have it all back together. I should have marked all the wires that I unplugged to work on the engine; but I didn't. silliy me. Now I can't figure out what goes where. Any help...

Hi Guys. I am replacing the head gaskets and need help finding a part number for an exhaust stud kit for my GN. Any help would be appreciated. Thanx in advance.

Hi Guys. Not related to my GN; but hope to get help finding a transmission lockup switch for my 1988 olds Cutlass Supreme. The part number on it is 8634475 and it is a normally closed switch. All I can find are normally open lockup switches. Any help would be appreciated. Thanks in advance...

Ok. Found the problem. It was the brake light switch under the dash. Thanks

Hi Guys. I replaced the third and fourth lockup switches and the lockup solenoid and still no lockup. Any help would be appreciated. Thanks Guys

I don't want it too loud. just on the mellow side. Right now it just has a hum.

Hi again. right now my GN has 2 ATR Pit Bull SS mufflers. They are 2 1/2" Center in and out. They are oval 13 1/2" and 18" overall length wth SS clamps.