PaulRV6's latest activity
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
PPaulRV6 replied to the thread Is this the correct ecm.Ok so I can just swap the wires instead of the TPS sensor??
-
PPaulRV6 replied to the thread Is this the correct ecm.It looks like the wiring is switched on the 84 from the 86. I think if I swap terminals A to C and C to A it should be correct for the...
-
PPaulRV6 replied to the thread Is this the correct ecm.I thought at idle the TPS output should be .45v across term b and c. I get 4.88v and when I move towards wide open the v goes down...
-
PPaulRV6 replied to the thread Is this the correct ecm.Ok so I didn't give up on the engine just my turbo link. I swapped out the computer from the test engine w/o calpack to my 86 GN and it...
-
PPaulRV6 replied to the thread Any fix for turbolink 4.0 and windows 10.I know this is way old but do you still have the Black turbolink connectors? I'm not sure if the cable electronics are broken or what so...
-
PWhat would cause the ECM to not communicate with my turbo link? The car runs fine but when I plug the scan tool into the ALDL it says...
-
PI know this scan tool is outdated but it's what I have used for years. The last time I used it was 2 to 3 yrs ago and it worked fine. I...
-
PPaulRV6 replied to the thread Is this the correct ecm.Well I didn't get too far today my turbo link was not working. Tried it on my 86 that I use it on and it won't connect to that either...
-
PPaulRV6 replied to the thread Is this the correct ecm.Ok just tried reading codes and it only gave me 12 12 12 and ended with 12 12 12. One thing was I could hear the IAC motor doing a bunch...
-
-
PPaulRV6 replied to the thread Is this the correct ecm.Ok I have a steady service lite on w/ign on. I will follow steps to read codes but still don't understand the output. It says for ex...
-
PPaulRV6 replied to the thread Is this the correct ecm.Ok I will work on that tomorrow. But what will the ses lamp being on tell me? I just want to figure out why I don't get the noid lite to...
-
PPaulRV6 replied to the thread Is this the correct ecm.I don't have the ses lite connected but I'm sure it would be on. I have a turbo link program that reads off of the ALDL connector but...
-
PPaulRV6 replied to the thread Is this the correct ecm.Correct and I have that and also G6 to my fuel pump. What I am wondering is it doesn't even get fuel to the injectors on cranking...
-
PPaulRV6 replied to the thread Is this the correct ecm.With all that said I am still trying to get the noid test lite to come on. I don't have the MAP sensor plugged in, do I need that...
-
PPaulRV6 replied to the thread Is this the correct ecm.To be clear about this I didn't want to bore everyone with info that I might have thought was not pertinent but here goes. This is on my...
Latest posts
-
-
Looking for a set of manual Seat tracks with feet cut and rewelded- Latest: 1986 Buick GX1
-
-
