Recent content by protracracing

  1. P

    Harland Sharp roller rockers

    I have a brand new set of 1.65 Harland Sharp roller rockers for stock iron heads. $500 shipped to lower 48. Thanks Dennis
  2. P

    1987 Buick turbo t roller

    Any rust?where are you located? Thanks Dennis
  3. P

    XFI pinout

    Found it. Thanks
  4. P

    XFI pinout

    Do you have a link ?I dont see it.
  5. P

    XFI pinout

    Where can i find the pinout for the XFI box?I looked on there web site but I can't find it. Thanks Dennis
  6. P

    New project 88 mustang

    The Best ET was an 8.92 at 154mph .it weighed 3275lbs with me in it.Car was sold in early 2007. The new car is only going to run about high 9's low tens.stockish motor and dont want to break it.
  7. P

    New project 88 mustang

    Ford guys didnt like my old buick powered mustang.So I am sure they wont like this one either. LOL
  8. P

    New project 88 mustang

    Classic Fast for the Buick set up.and mircosquit for the LS setup.going run both in the car.i have a few Buick races I want to run that is why I did it.
  9. P

    New project 88 mustang

    I just ran the downpipe throw the the lower part of the passanger side fender.I do think i could snake a downpipe to the back of the car. the intercooler is not to hard.I ran piping inside the fenders.If you are running a AJE k-member I can build you set of motor mounts. I have a jig to build...
  10. P

    New project 88 mustang

    I should have it done in a couple of months.
  11. P

    Running this class a BG this year?

    Good to hear.I am putting a car together for this class.
  12. P

    Running this class a BG this year?

    Is this class going to be run at BG this year or at any other buick races? Thanks Dennis
  13. P

    WTB:Roller Rocker for iron head.

    Still looking.
Top