Recent content by Rancor
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
R
Headlight Issue
Yes, The Harness from the Starter to Fuse Panel Melted (To close to the exhaust) I had to replace the melted section... Took a test light and about an hour to figure it out.. LOL.. I work in electronics so Soldering a new section was not that bad... I simply disconected the harness from the...- Rancor
- Post #3
- Forum: General Turbo Buick Tech
-
R
Headlight Issue
Hello Guy's. I have lost my headlights??? All fuses are fine it also takes down my radio/Inteerior lights and PWR Locks when I turn the lights on... Twilight sensor? Thanks in advance... Mark- Rancor
- Thread
- Replies: 4
- Forum: General Turbo Buick Tech
-
R
87 GN For sale in Toronto
Here is my ad on Kijiji.. some pics. 87 Grand National 3.8L SFI Turbo - Toronto Cars For Sale - Kijiji Toronto- Rancor
- Post #2
- Forum: Cars for sale
-
R
87 GN For sale in Toronto
Hello all: I am selling my 87 GN...(115XXX KM) It has the following Mods/Parts Upgraded Turbo T3. Hooker Downpipe/Adjustable Wast gate. ScanMaster Alburn Rear End Weld Pro Stars 15x7 F 15x8 R New Rad (last Year) New 40lbs Injectors (1000KM Ago) New Cam Sensor (1000KM Ago) New o2...- Rancor
- Thread
- Replies: 1
- Forum: Cars for sale
-
R
Throttle Body
Hello all... There are 2 line that come off the throttle body. (pass side) and (bottom pointing to pass side). What are they for and where do they go? Manafold Vacumme? Thanks Mark- Rancor
- Thread
- Replies: 3
- Forum: General Turbo Buick Tech
-
R
no power question
Try This... Turbo Regal Engine Grounds- Rancor
- Post #2
- Forum: General Turbo Buick Tech
-
R
Fuel Injectors.
OK I got the Injectors back today and the car still sputters???? I am at a loss on what i should do next.... Any Thoughts???? I have checked my vaccume lines and they all look good.. I am LOST.. Thanks Mark- Rancor
- Post #20
- Forum: General Turbo Buick Tech
-
R
Fuel Injectors.
OK I did the fuel test last night and do get Pressure drop when both the in/out are Clamped.. I will have the Injectors checked today...\- Rancor
- Post #19
- Forum: General Turbo Buick Tech
-
R
Fuel Injectors.
OK OK... You guys are right...... Yes i had convinced myself is was the Pump but know now i was way off. Once the wife gets home I will do the check List and report back. Shoild i not get a code if a Injector(s) are bad???? I have pulled the plugs and they are fine. Any how thanks...- Rancor
- Post #17
- Forum: General Turbo Buick Tech
-
R
Fuel Injectors.
OK Guys..... I have replaced the Fuel Pump (Walbro 255) FPR (holly adjustable) New Chip for my Injectors (42.5#) All Injector Seals and still the car is runnen like crap and will not hold Fuel pressure after shut down... It has to be a bad injector right????? Should I change them out or have...- Rancor
- Post #14
- Forum: General Turbo Buick Tech
-
R
Fuel Injectors.
Anyone know th Walbro Fuel pump Part# 255?? I need to get one to make sure is is not the pump... The pump is wired through a fuse and relay.. It will hold pressure at Idle but am not sure when driving so i might as well change it out, then i will only have Injectors left... This is kicken my...- Rancor
- Post #12
- Forum: General Turbo Buick Tech
-
R
Fuel Injectors.
I just noticed that my Fuel Pump is Hot Wired!!!! The guy who had it befor me must have done this. Will this hurt the pump if it is connected to the Alt constantly???? It is making alot of noise and is new.... If i tap the tank it will quiet down for a bit but after a few Min it is loud...- Rancor
- Post #9
- Forum: General Turbo Buick Tech
-
R
Fuel Injectors.
Going to get a chip from Ken Siggy tomorrow, if that fixes the Issue I will buy one from TT next week... On a side note I have replaced both the Fuel Pump and Regulator (holly adjustable) so don't think it would be eather.. I will try a MAF tonight... Mark- Rancor
- Post #8
- Forum: General Turbo Buick Tech
