salvageV6's latest activity

Welcome!

By registering with us, you'll be able to discuss, share and private message with other members of our community.

SignUp Now!
  • salvageV6
    salvageV6 replied to the thread Power Antenna stopped working.
    Probably one of the switches inside the antenna itself. If you have verified the signals are proper out of the relay, it's either the...
  • salvageV6
    salvageV6 reacted to chris romani's post in the thread Blast from the past with Like Like.
    In 1988 I was 17 I had a Monte SS and bought the Hypertech chip I couldent wait to put it in .I paid the Chevy dealer an hour labor to...
  • salvageV6
    salvageV6 reacted to Red Sector 7's post in the thread Blast from the past with Like Like.
    Back in the early 1990s I tried all three of those chips. The Pitbull, Eastern's 'Street Lethal' and Kenne Bell's 'Hi-Lo Pro. The Street...
  • salvageV6
    salvageV6 replied to the thread Brake Lights.
    Here's the diagram that shows C104 harmonica connector and the wire that comes off the brake switch into the hazard assembly in the...
    • IMG_0765.JPG
  • salvageV6
    salvageV6 replied to the thread Brake Lights.
    You need to get to the right side of the steering column up top, undo the drivers side black lower panel, two screws and a 10mm nut...
    • IMG_0761.JPG
    • IMG_0762.JPG
    • IMG_0764.JPG
  • salvageV6
    salvageV6 replied to the thread Exhaust hangers.
    Carquest 8200 has a nice piece of rubber if that's what you need, if you can source one. Hangers are normally used behind the mufflers...
    • CarquestExhstrapbox.JPG
    • CarquestExhstrap4.JPG
  • salvageV6
    salvageV6 reacted to william B.'s post in the thread bla bla with Like Like.
    Im in arkansas,dont need doors,hood,trunk lid,fenders,exhaust,glass,do need working lights and seat belts, no inspections, not a bad...
  • salvageV6
    salvageV6 reacted to jlat's post in the thread car cover with Like Like.
    hello peoples: I just ordered a Seal Skin cover and I'm wondering has anyone here has tried one. This is my first cover. Wish me luck. IBBY
  • salvageV6
    salvageV6 replied to the thread car cover.
    There's not a day that goes by that I don't wish you luck. ;) :p
  • salvageV6
    I did a rough measurement of a 1987 pulley and it was 5" groove to groove. Jaws weren't wide enough on the calipers to get an...
  • salvageV6
    salvageV6 replied to the thread Stayed In Today.
    My cat doesn't seem too concerned about bears. ;) I think Big Mama wanted a ride on the Craftsman I was just working on. Same...
    • NVR-3-FRONT YARD-20250711062959-20250711070000 (2)_58.jpg
    • NVR-BACK DOOR-20250811_231532.jpg
  • salvageV6
    salvageV6 reacted to TexasT's post in the thread ad block pop up with Like Like.
    I don't want to sound like I'm ungrateful for the site. I even clicked the on where you might upgrade but went to a place that sez no...
  • salvageV6
    salvageV6 reacted to Buckshot G/N's post in the thread Always draws a crowd with Like Like.
    Definitely a crowd pleaser, sharp representation for our Buick Community
  • salvageV6
    salvageV6 reacted to Atompilot's post in the thread Always draws a crowd with Like Like.
  • salvageV6
    salvageV6 reacted to Atompilot's post in the thread Always draws a crowd with Like Like.
Back
Top