Cant remember where I got the covers, they are standard covers that also had the bolt holes in the center so I drilled and taped for the blue plugs. The oil pump is a single stage Peterson wet sump pump. The pump on the drivers side is a BG mechanical fuel pump, it and the carb are not...
Virgin standard bore Stage II block on center
BMS 3.625 crank std/std
Crower 6.5 rods
Ross -20cc forged pistons
Stage II heads fully ported with titanium valves and roller springs
Comp solid roller
Moroso Pan
Peterson external oil pump
Dawson coated headers
Garrett turbos
Tial...
Im working on my cam setup right now. The normally aspirated cam that was in my motor when I got it has been machined to accept a thrust washer but its just a washer no bearing. Is the thrust waser sufficient or do I need something else? I am using a double roller chain. Thanks and good thread.
What rear seal does a stage 2 take? I ordered one from TA performance and its the wrong one. The cap and block look like it takes a style similar to a sbc.
Im looking for a twin inlet single outlet intercooler that is capable of supporting about 1200 hp. Is there anything available off shelf or will I need to go custom? I whould prefer 1 inlet on each side and single outlet in the top/center.