Recent content by Walt03

I really enjoyed this technical article. Like the forum used to have with people in the know that have sold cars. I'm getting the fever back with my car off the road for 10 years. Bison, keep up the good work. Walt

Looked at Zeitronix, AEM, Innovative, PLX and Autometer Need a monitor that will be compatible with the GN and a carburetor car. I will purchase a powerlogger for GN at some point so everyone's advice will be considered. Thank you for your input.

204/214 CAM SPECS and events are: Intake @ .006 opens 23 BTDC, closes 77 ABDC Int CL 112 Exhaust @ .006 opens 72 BBDC, closes 38 degrees ATDC Exh CL 112 No advance ground in LSA 112 I the comp 206/210 roller at 112 LSA COMPARABLE , IF NOT WHAT IS?

Data on the 204/214 at .050 lift are Intake @.006 opens 23 BTDC

What roller cam grind has the intake and exhaust open and closing events comparable to the FT 204/214 Edelbrock cam?

I've been away for 10 years and have a motor apart getting the itch to put it together from my 17 year old grandson. Somewhere I read to use 95 Buick 3800 bearing for rods. Do they come in oversizes to take up the slack in polishing the crank? .001-.002 mains, and same for oversize on...

I have accumulate some of the same stuff but I have a question. I was going to use the stock lifters and adj pushrods but haven't decided on a cam. I have a 3:73 gear and this is only a street car on 255/60's. What roller cam would work good with this? 200,206,210,218,220? lba 110,112,? need...

Am thing about this turbo to work with a 2600-2800 10" LU converter primarily on the street at low 20+ boost. Anyone have similar combo?

Is the LSA on the cam 212?

Is the 212/212 cam, .536, with 112 LSA better than a 110 LSA for this application?

Why is there a U shaped cut out on the end that joins the downpipe? What is the little bypass pipe? I didn't think RA's Cat came with that. Thanks

My 1997 SC is passing a little oil from behind the front pulley. I have 230K miles on the Park Avenue Ultra with no trouble but I would like to rebuild it myself B4 noises begin and need to know where to get the rebuild kit and how to rebuild it. Any information on the snout rebuild kit and...

For the V-6 turbo, is Comp Cams the ONLY one out there grinding Cams for the V-6 turbo. I was wondering about Erson Lunati, Engle, or Isky cams. Has any TB members used anyone beside COMP Cams?