Recent content by X Ray
Welcome!
By registering with us, you'll be able to discuss, share and private message with other members of our community.
-
-
-
Stock ignition coil tester.
Looking to buy or barrow oem ignition coil pack tester Thanks- X Ray
- Thread
- Replies: 5
- Forum: Parts wanted
-
“Bowling green custom downpipe elbow”
Running a TA engine with a 62/65 turbo with about 500 hp....no issues with flow. Yes I like it. After reviewing your nice combo you will have no issues in my opinion. Regards- X Ray
- Post #11
- Forum: General Turbo Buick Tech
-
“Bowling green custom downpipe elbow”
I use .one....I unfortunately received mine near the end of there run as a business and it had a hole in it ....sent it back and the same issue. Being a fabricator and welder I repaired it with inconel welding rod then ground off he BGC . LOL . But I like it and had no further issues. But you...- X Ray
- Post #6
- Forum: General Turbo Buick Tech
-
Wuz up at the Nats?
I would like to thanks Eric Mashall and Bob Bailey for helping me diagnose my engine issue. I went to drive my car before coming to the Nationals and I noticed it wasn’t running well. Bob did the original tune on my car as he lives near me in Michigan. Bob and Erick jumped in and before we went...- X Ray
- Post #10
- Forum: Turbo Lounge
-
-
Any chance it's a real GNX?
Kirban wheels, as mentioned X brace and aftermarket Flares as no mounting brackets on passenger side and the plastic flares on the rear should have melted in the fire.- X Ray
- Post #6
- Forum: Cars for sale
-
Need enclosed trailer to rent for going to the MCACN NOV 21
Thanks ....nice pictures....was a great event to be involved with!- X Ray
- Post #5
- Forum: Turbo Lounge
-
Need enclosed trailer to rent for going to the MCACN NOV 21
Looking for an enclosed trailer to take my car to this event the end of NOV . The Muscle Car and Corvette Nationals that is held north west of Chicago. I am located west of Detroit. PM me for more information if interested in helping me out.- X Ray
- Thread
- Replies: 4
- Forum: Turbo Lounge
-
GNX ,Prototypes,Parts,Build Info, EXC
I guess I am getting old when a picture of me is called historical....LOL- X Ray
- Post #308
- Forum: GNX - The fortunate 547
-
-
GNX ,Prototypes,Parts,Build Info, EXC
Here is some history for you all...this T shirt is the one worn at the plant for this PIC in the GNX book. I do not know of anyone else that has theirs but I still have mine. The second picture is the book picture ....I am circled....I had hair at this time...LOL- X Ray
- Post #306
- Forum: GNX - The fortunate 547
-
Alky Box and Scanmaster g mount.
Thanks.....it was either this or a pillar mount. I like coming up with new things so this was it. FYI: I have a GNECU and the original scanmster so I needed to go into the GNECU box and change a switch so the scanmaster g would read properly .- X Ray
- Post #3
- Forum: Fabrication-**No Solicitation**
-
Alky Box and Scanmaster g mount.
I took a plastic electronic box and used it to mount my alky control lights so I would not need to modify the vehicle. I also took a gouge holder and reworked it to to mount my scanmaster g and mounted both on a 1/4 piece of aluminum that I painted black.- X Ray
- Thread
- Replies: 3
- Forum: Fabrication-**No Solicitation**
