For everyone running the 3.8L Series II engine found on many 97 and newer GM vehicles, I have a Magnuson S/C snout for sale. This snout will allow you to change different pullies to increase boost in about 10 minutes. Below is the link for the snout.
Magnuson Nose Drive: PFYC
The snout runs $429 plus shipping and the individual pullies run $95 each with shipping. With thise snout you will get the 3.4" pulley to increase boost from stock 6-7psi to 10-11psi. Boost will be a lot faster and it will increase HP 35-45HP depending on mods. Also including are 3.25" pulley and a 3.0" pulley. These will increase boost to 13/15psi. Use these when using higher ocatane fuel (ie race gas) or for future mods (ie cam, heads, exhuast, ect)
I will also throw in S/C oil to make install a breeze. $365 shipped obo. This will go on Ebay next week, but wanted to give you guys first dibs!
Part of my setup when I ran 12.7 @ LACR (best of 12.5 that day) in 109 degree heat with poor traction (2.1 60') So you know it works!
YouTube - My 2000 Pontiac GTP Running 12's @ LACR
Magnuson Nose Drive: PFYC
The snout runs $429 plus shipping and the individual pullies run $95 each with shipping. With thise snout you will get the 3.4" pulley to increase boost from stock 6-7psi to 10-11psi. Boost will be a lot faster and it will increase HP 35-45HP depending on mods. Also including are 3.25" pulley and a 3.0" pulley. These will increase boost to 13/15psi. Use these when using higher ocatane fuel (ie race gas) or for future mods (ie cam, heads, exhuast, ect)
I will also throw in S/C oil to make install a breeze. $365 shipped obo. This will go on Ebay next week, but wanted to give you guys first dibs!
Part of my setup when I ran 12.7 @ LACR (best of 12.5 that day) in 109 degree heat with poor traction (2.1 60') So you know it works!
YouTube - My 2000 Pontiac GTP Running 12's @ LACR
:biggrin:
