4.1 J&E stage pistons

[incharge]

I have 8 new J&E forged flat top pistons with pins and locks that are about 10 years old here are the specs that J&E gave me they are for a 4.020 bore 1.200 compression height and they have a dike .017 top ring .016 second ring and a 3/16 oil ring these were for a naturally asperated engine and would be a lot of compression best offer on these

 

[incharge]

also have a new set of Childs & Albert set of rings for these

 

[incharge]

$200.00 with the rings.. before they go to EBAY

 

[GARY HARVEY]

What size wrist pins (will they fit a SBC)?
Be nice if you could supply all the info or a link.

 

[49-blues]

Any idea what hp the wristpins are rated for?

 

[incharge]

No idea, but being that the assembly was bought balanced with a billet crank and big block chevy OLIVER rods I would say very strong. I might be using these as I was told that they might be in the hole .100 and that would give me about 9 to 1 compression I am going to assembly the short block and measure for sure...

 

[James'6]

JE pistons

IMO be sure YOU cc your heads and do not listen to all that "they should be"stuff. I'm just saying KNOW your comp. for certain.